Description: This routine will dynamically display the resistance of photoresistor on OLED with dynamic graphical effects.
Components:
SunFounder Uno R3 * 1
0.96 Inch OLED * 1
Photoresistor* 1
10K Ohm Resistor * 1
USB Data Cable * 1
Jumper Wires
Steps:
First, connect the circuit
SunFounder Uno OLED
SCL -------------------------------------- SCL
SDA ------------------------------------- SDA
3.3V-------------------------------------- VCC
GND ------------------------------------ GND
The connection between SunFounder Uno and the photoresistor is as shown in figure 20:
Figure 20
The corresponding principle diagram is as shown in figure 21:
Figure 21
Second, program (please go to our official website www.sunfounder.com to download the example code by clicking LEARN -> Get Tutorials)
Third, compile the program
Fourth, burn the program into SunFounder Uno R3 board
You will see the height of bar that is used to indicate light intensity is proportional to light intensity, and the corresponding physical connection diagram is shown as figure 22: