Introduction
In this experiment, you will learn how to turn on/off an LED by using an I/O port and a button. The “I/O port” refers to the INPUT and OUTPUT port. Here the INPUT port of the SunFounder Uno board is used to read the output of an external device. Since the board itself has an LED (connected to Pin 13), so you can use this LED to do this experiment for convenience.
Components
– 1 * SunFounder Uno board
– 1 * USB cable
– 1 * Button
– 1 * Resistor (10kΩ)
– Jumper wires
– 1 * Breadboard
Principle
Button
Buttons are a common component used to control electronic devices. They are usually used as switches to connect or disconnect circuits. Although buttons come in a variety of sizes and shapes, the one used here is a6mmmini-button as shown in the following pictures. Pins pointed out by the arrows of same color are meant to be connected.
When the button is pressed, the pins pointed by the blue arrows will connect to the pins pointed by the red arrows.
Generally, the button is directly connected in an LED circuit in order to turn on or off the LED. This connection is relatively simple. However, sometimes the LED will light up automatically without pressing the button, which is caused by various interferences. In order to avoid these external interferences, a pull-down resistor is used, that is, to connect a 1K–10KΩ resistor between the button port and GND. It is used to consume external interferences while connected to GND for as long as the button switch is turned off.
This circuit connection is widely used in numerous circuits and electronic devices. For example, if you press any button on your mobile phone, the backlight will light up.
Experimental Procedures
Step 1: Build the circuit
The schematic diagram
Step 2: Program (please go to our official website www.sunfounder.com to download related code by clicking LEARN -> Get Tutorials)
Step 3: Compile the code
Step 4: Upload the sketch to the SunFounder Uno board
Now, press the button, and the LED on the SunFounder Uno board will light up.
Code
| //Controlling Led By Button //Turns on and off a LED ,when pressings button attach to pin12 //Email:support@sunfounder.com //Website:www.sunfounder.com //2015.5.7 /**********************************/ const int keyPin = 12; //the number of the key pin 12 const int ledPin = 13;//the number of the led pin 13 /**********************************/ void setup() { pinMode(keyPin,INPUT);//initialize the key pin as input pinMode(ledPin,OUTPUT);//initialize the led pin as output } /**********************************/ void loop() { //read the state of the key value //and check if the kye is pressed //if it is,the state is HIGH if(digitalRead(keyPin) ==HIGH ) { digitalWrite(ledPin,HIGH);//turn on the led } else { digitalWrite(ledPin,LOW);//turn off the led } } /************************************/ |
Video